top of page
Writer's pictureJeremy

Making an Artisan Caliper

I've been slowly working on these calipers for ages, trying to be a perfectionist and all. So I finally decided to just finish them and be done with it. All in all, this video is a compilation of clips over an 8 month period.


The calipers are stainless steel and brass. All the stainless machining was done on a Comet mill, and the brass turned on a Taig lathe and milled with a Carbide3d Nomad mill.


This was a fun little project, but it took way too long for my attention span. I hope you enjoy the video though!


0 comments

Recent Posts

See All

Comments


Book Image.png

Check out
my books!

bottom of page